Remove/Install Tilting/Sliding Roof Panel - AR77.20-P-1000ME
Model 167.1
With Code 414 (Electric sunroof, glass version)
Shown on right side of vehicle
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Open sun protection (3). | ||
| 2 | Move sliding roof panel (1) to tilt position. | ||
| 3 | Remove boot (2) on left and right. | Otherwise the boot (2) on left and right can be damaged by bending. |
|
| 4 | Unscrew screws (4) at left and right. | ||
| 5 | Remove sliding roof panel (1). | ||
| 6 | Install in the reverse order. | ||
| Adjust | |||
| 7 | Adjust sliding roof panel (1). | AR77.20-P-1100ME |