Remove/Install Rear Shelf - AR68.30-P-4581MEX
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.
Model 167.9
With Code M036 (Maybach version)
MODIFICATION NOTES
| 24.02.2020 | Method revised. | Operation steps 4 to 8 |
Shown on the left side of vehicle
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove left and right side load compartment trim. | AR68.30-P-1185MEM | |
| 2 | Remove expansion rivets (1) and lower trim (2) until electrical connectors of load compartment lamps (E18/4, E18/5) can be accessed. | Fig 1 | |
| 3 | Disconnect electrical connectors of load compartment lamps (E18/4, E18/5) and remove trim (2). | ||
| 4 | Mark position of screws (3, 5). | ||
| 5 | Remove screws (3) and remove angle pieces (4). | ||
| 6 | Remove bolts (5). | ||
| 7 | Unhook cables of rear shelf (6) at tailgate. | ||
| 8 | Release rear shelf (6) at left and right from below (arrow), fold downward, and remove from vehicle. | ||
| 9 | Install in the reverse order. |