Remove/Install Glass Roof On Tilting/Sliding Roof - AR77.20-P-2852LW
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2023 Mercedes-Benz C43 AMG, 2022 Mercedes-Benz C43 AMG, 2021 Mercedes-Benz C43 AMG, 2020 Mercedes-Benz C43 AMG, and 2019 Mercedes-Benz C43 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 205.0/1
with code 414 (Sliding sunroof)
Model 213.0/1/2
with code 414 (Sliding sunroof)
Model 253
with code 414 (Sliding sunroof)
Model 293
with code 414 (Sliding sunroof)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Move sliding roof panel (1) to tilt position. | ||
| 2 | Open sliding roof trim (3). | ||
| 3 | Remove boot (2) on left and right. | Extend boot (2) on left and right first, then at bottom and then at top. Otherwise the boot (2) on left and right can be damaged by bending. |
|
| 4 | Remove screws (4) on the left and right. | ||
| 5 | Remove sliding roof panel (1). | ||
| 6 | Install in the reverse order. | ||
| 7 | Adjust sliding roof panel (1). | Model 205.0/1 with code 414 (Sliding sunroof) Model 213.0/1/2 with code 414 (Sliding sunroof) |
AR77.20-P-1100LW |
| Model 253 with code 414 (Sliding sunroof) |
AR77.20-P-1100CW | ||
| Model 293 with code 414 (Sliding sunroof) |
AR77.20-P-1100EQ |