Remove/Install Inertization Cartridge - AR86.10-P-0106MFC
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 247 with engine 260, 282
with code 2U8 (Alternative refrigerant)
Model 118, 177, 247.7 with engine 139
with code 2U8 (Alternative refrigerant)
Shown on model 177.0 with code 2U8 (Alternative refrigerant)
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Remove/install | |||
| 1 | Remove cover for air/water duct. | Model 118, 177 with engine 139, 260, 282 with code 2U8 (Alternative refrigerant) |
AR83.10-P-1411MFA |
| Model 247 with engine 260, 282 with code 2U8 (Alternative refrigerant) Model 247.7 with engine 139 with code 2U8 (Alternative refrigerant) |
AR83.10-P-1411MFB | ||
| 2 | Detach ground line of on-board electrical system battery. | AR54.10-P-0003MFA | |
| 3 | Unclip retaining clip (2). | Fig 1 | |
| 4 | Release and disconnect electrical connection (3). | Fig 2 | |
| 5 | Remove retaining clamp (4) and disconnect line (5) from inerting system cartridge (1). | ||
| 6 | Remove nuts (6). | *BA86.10-P-1001-03K | |
| 7 | Remove inerting system cartridge (1). | ||
| 8 | Check seal on connection of line (5) to inerting system cartridge (1) for damage. | If damage is present, ↓ replace inerting system cartridge (1). |
|
| 9 | Install in the reverse order. |
INERTING SYSTEM
| Number | Designation | Model 118 | Model 177 | ||
|---|---|---|---|---|---|
| BA86.10-P-1001-03K | Nut, inerting system cartridge to body | M6 | Nm | 8 | 8 |
INERTING SYSTEM
| Number | Designation | Model 247 | ||
|---|---|---|---|---|
| BA86.10-P-1001-03K | Nut, inerting system cartridge to body | M6 | Nm | 8 |