Remove/Install Cover For Air/Water Duct - AR83.10-P-1411MFA

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 118

Model 177

MODIFICATION NOTES

21.06.2022

Remove screws (8) and remove suspension strut tower connecting strut (9).

Operation step 3, newly added.

Courtesy of MERCEDES-BENZ USA

Shown on model 177.0

Courtesy of MERCEDES-BENZ USA

Shown on model 118

Courtesy of MERCEDES-BENZ USA

	Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism.	When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m).	AS82.30-Z-0001-01A
	Remove/install
1	Remove cover above on-board electrical system battery.	: Ensure that guides are seated correctly.	AR54.10-P-0003MFA
2	Remove wiper arms.	: Make sure that the driver's side wiper arm is in the upper position.	AR82.30-P-6100MFA
3	Remove screws (8) and remove suspension strut tower connecting strut (9).	Model 118, 177 with engine 139 with code M20 (Displacement 2.0 liter) Model 118, 177 with engine 260 with code M016 (Uprated engine) Only release and tighten screws (8) of suspension strut tower connecting strut (9) when the vehicle is standing on its wheels. Otherwise, the suspension will be under tension and this will affect the camber. Screw, center strut to suspension strut tower holder	*BA62.30-P-1012-02O
4	Release drip rails in the area of the windshield.		AR88.80-P-4000MFA
5	Unclip electrical connectors (2) from cover of air/water duct (1), unhook electric lines from retaining clamps (7) and place to one side.
6	Remove nuts (3).
7	Release holders (4) and remove cover of air/water duct (1).	: Make sure that the sealing lip (5) is completely inserted into the gap (6). : Make sure that the holders (4) are correctly locked.
8	Install in the reverse order.

FROND END WITH FRONT REINFORCEMENT

Number	Designation			Model 118	Model 177
BA62.30-P-1012-02O	Screw, center strut to suspension strut tower holder	M10	Nm	30	30