Remove/Install Front Stabilizer Bar - AR32.35-P-2050GW
Model 463 (except 463.234/255/274) as of model year 2013 up to model year 2019
Shown on model 463.270
Fig 1: Front Stabilizer Bar Components Location (Shown On Model 463.270) - Model 463 (Except 463.234/255/274) As Of Model Year 2019
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Remove/install | |||
| 1 | Lift/jack up vehicle | Model 463 (except 463.234/255/274) as of model year 2013 up to model year 2019 | AR00.60-P-1000-01G |
| 2 | Unscrew nuts (2) | *BA32.35-P-1001-01A | |
| 3 | Detach holder (3) from trailing arm | ||
| 4 | Remove heat shield (4) | If installed. | |
| 5 | Release threaded connection (5) and remove stabilizer bar (1) with stabilizer bracket (6) | *BA32.35-P-1003-01A | |
| 6 | Detach stabilizer bracket (6) from stabilizer bar (1) | When replacing the stabilizer bar (1). |
*BA32.35-P-1002-01A |
| 7 | Check decoupling element for wear and damage and replace, if necessary | ||
| 8 | Install in the reverse order |
STABILIZER BAR/TORSION BAR
| Number | Designation | Model 463 as of model year 2019 | |
|---|---|---|---|
| BA32.35-P-1001-01A | Nut, stabilizer bar mounting bar to trailing arm | Nm | 50 |
STABILIZER BAR/TORSION BAR
| Number | Designation | Model 463 as of model year 2019 | |
|---|---|---|---|
| BA32.35-P-1002-01A | Nut, stabilizer bar to stabilizer bracket | Nm | 90 |
STABILIZER BAR/TORSION BAR
| Number | Designation | Model 463 as of model year 2019 | |
|---|---|---|---|
| BA32.35-P-1003-01A | Nut, stabilizer bracket to frame | Nm | 90 |