Remove/Install Upper B-Pillar Trim - AR68.30-P-4703XG

Model 463 

as of model year 2019 

Shown on left side of vehicle 

Fig 1: Upper B-Pillar Trim Components Location - Model 463 As Of Model Year 2019 (Shown On Left Side Of Vehicle)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Disconnect ground line of battery.		AR54.10-P-0003XG
2	Remove the trim at the bottom of the B-pillar.		AR68.30-P-4704XG
3	Remove the seat belt end-fitting tensioner.		AR91.40-P-1030-02XG
4	Loosen the edge guard (2) in the area of the trim at the top of the B-pillar (1).	Ensure that the edge guard (2) is seated correctly.
5	Unclip the trim at the top of the B-pillar (1) at the retaining tabs (4) and pull downwards until the guides (5) are free.	Position the mount (6) for the trim at the top of B-pillar (1) on the screw for the seat belt guide bracket.
6	Unclip the cover (7), guide the seat belt out and remove the trim at the top of the B-pillar (1).
7	Remove the air duct (3) from the trim at the top of the B-pillar (1).	When you are replacing the trim at the top of the B-pillar (1).
8	Install in reverse order.