Remove/Install Stabilizer Bar At Front Axle - AR32.35-P-2200LWQ

Model 238 

with code M005 (Vehicles with 4MATIC/all-wheel drive) 

Fig 1: Front Stabilizer Bar Components Location - Model 238 With Code M005 (Model 238.3 Shown)

Courtesy of MERCEDES-BENZ USA

Shown on model 238.3 with code M005 (4MATIC) 

	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Note on calculation of tightening torque when using insertion or socket tools with various effective lengths		AH00.00-P-0015-01CW
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Remove cross struts (3)		AR61.10-P-5143LWO
2	Remove front diagonal strut	Model 238.4 with code M005 (Vehicles with 4MATIC/all- wheel drive)	AR61.10-P-5144LWO
3	Loosen bolts (4)	Bolt, torsion bar to front axle carrier	*BA32.20-P-1004-02R
4	Remove left and right torsion bar linkage (5) from stabilizer bar (1)	Torsion bar linkage to torsion bar	*BA32.20-P-1005-02R
5	Remove right suspension strut from spring link	Model 238 with code 489 (AIR BODY CONTROL) with code M005 (Vehicles with 4MATIC/all- wheel drive)	AR32.25-P-1017LWQ
6	Unscrew bolts (4) and lower stabilizer bar (1)	: Fit bolts (4) but do not tighten.
7	Extend stabilizer bar (1) and remove towards rear	Model 238 with code 489 (AIR BODY CONTROL) with code M005 (Vehicles with 4MATIC/all-wheel drive) Push right suspension strut outwards to the side.
8	Install in the reverse order