Remove/Install Stabilizer Bar At Front Axle - AR32.35-P-2200LWO

Model 238

Except Code M005 (Vehicles with 4MATIC/all-wheel drive)

Fig 1: Front Stabilizer Bar Components Location - Model 238 Except Code M005

G15377727

TORQUE SPECIFICATION

Courtesy of MERCEDES-BENZ USA

	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Lower front axle	Model 238 except code M005 (Vehicles with 4MATIC/all- wheel drive) Model 238.3 except code M005 (Vehicles with 4MATIC/all- wheel drive)	AR33.10-P-0100LWO
2	Detach both torsion bar linkages (2) from stabilizer bar (1)		AR32.35-P-3328LW
3	Unscrew screws/bolts (3), take off mounting bar (4) and remove stabilizer bar (1) to the side	Bolt, torsion bar to longitudinal member	*BA32.20-P-1001-02R
4	Install in the reverse order
5	Perform wheel alignment check		AR40.20-P-0200LWO

FRONT AXLE TORSION BAR

Number	Designation		Model 238 except code M005 (Vehicles with 4MATIC/all-wheel drive)
BA32.20-P-1001-02R	Bolt, torsion bar to longitudinal member	Nm	70