Remove/Install Rear Seat Heater Control Unit - AR91.30-P-0033LWO
Model 238.3
With Code 872 (Heated rear seats)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Perform initial startup of rear seat heaters control unit (N25/6) | When replacing the rear seat heaters control unit (N25/6). | |
| AD00.00-P-2000-06LWO | |||
| 2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 3 | Remove trunk floor and cover in trunk at front | AR68.30-P-4600LWO | |
| 4 | Unclip rear seat heaters control unit (N25/6) from bracket and disconnect electrical connectors (1) | ||
| 5 | Install in reverse order |