Remove/Install Inertization System Line In Engine Compartment - AR86.10-P-0119LWO

Model 213 with engine 256 

with code 2U8 (Alternative refrigerant) 

Model 238 with engine 256 

with code 2U8 (Alternative refrigerant) 

Shown on model 213 with engine 256 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Risk of injury  . Skin or eye injuries may result when handling hot or glowing objects.	Wear protective gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
Topical note	Notes on threaded connections fastened using a tightening angle-based tightening process		AH00.00-P-0020-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove cover in right engine compartment.
2	Remove engine cover.		AR01.10-P-2405MSA
3	Open clamps (3.1) for piping (3).	: Replace clamps (3.1) for piping (3).
4	Take off seal (1).
5	Remove piping (3) together with the passage (2).
6	Remove piping (3) from passage (2).
7	Unscrew screw (5) and remove piping (4).	Pipe for inerting to engine	*BA86.10-P-1002-03E
	Check
8	Check piping (3, 4) for damage and plugging.	If there is a problem, ↓ Replace the piping (3, 4).
9	Install in the reverse order.