LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> CLA45 AMG >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Interior Equipment -- 118 Chassis >> Testing & Repair >> Remove/Install Side Paneling In Rear - AR68.30-P-4780MFV

Remove/Install Side Paneling In Rear - AR68.30-P-4780MFV

Model 118.3/6, 177.1/9, 247.0/7 

MODIFICATION NOTES

09.12.2019 Remove corresponding seats in the rear passenger compartment. Operation step 2.2.  
G16051601Courtesy of MERCEDES-BENZ USA

Shown on model 177.1 

WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
REMOVINGINSTALLING Remove/install     
1 Remove C-pillar trim. Model 118.6 AR68.30-P-4498MFD
    Model 118.3, 177.1/9 AR68.30-P-4490MFV 
    Model 247.0/7 AR68.30-P-4490MFB 
2.1 Remove seat backrest in rear. Model 118.3/6, 177.1/9
Model 247.0/7
except code 567 (Vario rear seat)
Model 118.3, 177.1/9 except code 287 (Folding seat backrests in rear passenger compartment)
AR91.12-P-1713MFV
    Model 118.3/6, 177.1 with code 287 (Folding seat backrests in rear passenger compartment)
Model 247.0/7
except code 567 (Vario rear seat)
AR91.12-P-1713MFA
2.2 Remove corresponding seats in the rear passenger compartment. Model 247.0/7
with code 567 (Vario rear seat)
AR91.12-P-4026MFX
3 Remove tie-down eye (4). TORQUE SPECIFICATION Screw/bolt for tie-down eye *BA68.50-P-1001-03I 
4 Remove load compartment floor from trunk.    
5.1 Remove nuts (5) and remove mounting support (6). Model 118.3/6, 177.1/9  
5.2 Remove the fastening bracket (6) for the load compartment floor. Model 247.0/7  
6 Release trim at side in trunk until retaining clips (1) can be accessed. Model 247.0/7 AR68.30-P-4800MFB 
    Model 118.3, 177.1/9 AR68.30-P-4800MFV 
7 Carefully loosen the side paneling (2) on the retaining clips (1) and retaining clamps (3) and remove. INSTALLATION IMPORTANT : Replace damaged retaining clips (1) and retaining clamps (3).
Ensure that the edge guard is seated correctly in the working area.
SPECIAL TOOL Dismantling tool
Fig 1
8 Install in the reverse order.    
CARGO RETAINERS

Number Designation Model 118 Model 177, 247
BA68.50-P-1001-03I Screw/bolt for tie-down eye Nm 24 24
Fig 1: Identifying Dismantling Tool (000 589 95 63 00)
G12619044Courtesy of MERCEDES-BENZ USA