Remove/Install Rear Backrest Angle Switch - AR91.29-P-1772LW

Model 205.0/1, 213.0 

with code 287 (Through-loading feature) 

Model 205.2/3/4, 213.2, 238, 253, 293 

Fig 1: Rear Backrest Angle Switch Component Location - Model 205.0 With Code 287, Model 205.3/4 (Shown On Model 205.0 With Code 287)

Courtesy of MERCEDES-BENZ USA

Shown on model 205.0 with code 287 (Folding backrests in rear), on the left backrest 

	Remove/install
1.1	Remove left or right rear seat backrest.	Model 205.0/1, 213.0 with code 287 (Through-loading feature) Model 205.2/3/4, 213.2, 238.4, 253, 293
		Model 205.0/1, 213.0 with code 287 (Through-loading feature) Model 205.2/3, 213.2 Model 253 (except 253.992/993), 293	AR91.12-P-1720LW
		Model 205.4, 238.4	AR91.12-P-1721LWR
		Model 253.992/993	AR91.12-P-1721RFW
1.2	Remove right rear seat backrest.	When removing right rear backrest inclination switch (S54/6).
		Model 238.3	AR91.12-P-1722LWO
1.3	Remove left rear seat backrest.	When removing left rear backrest inclination switch (S54/5)
		Mode 238.3	AR91.12-P-1724LWO
2	Counterhold pivot bearing (1) and unscrew screw (2).	Do not jam bearing pin of pivot bearing (1). Otherwise the spacer ring in the backrest frame may be damaged.
		Bolt, pivot bearing to backrest frame	*BA91.12-P-1007-03M
3	Remove pivot bearing (1) with rear passenger compartment seat backrest inclination switch (S54/5, S54/6).	Ensure that guide pin (4) is seated correctly in backrest frame.
4	Remove locking pin (3).
5	Remove rear passenger compartment seat backrest inclination switch (S54/5, S54/6) from pivot bearing (1).	Check that the rear passenger compartment seat backrest inclination switch (S54/5, S54/6) is correctly seated in the pivot bearing (1).
6	Install in the reverse order.