Remove/Install Cable For Header Bow - AR77.33-P-1050LWP
Model 205.4
Model 238.4
Shown on left side of vehicle
Shown on left side of vehicle
Entire cable (1) route shown on left side of vehicle
| Risk of injury when performing check and repair work in area of roll bar | Keep body parts out of the area where the roll bars extend. Do not use the cover in the area of the roll bar as a storage place for objects. |
AS91.00-Z-0003-01LCA | |
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | AS00.00-Z-0009-01A | |
| Remove/install | |||
| 1 | Remove side paneling in trunk | AR68.30-P-4800LWR | |
| 2 | Remove side paneling in rear | Model 205.4 | AR68.30-P-4784LWR |
| Model 238.4 | AR68.30-P-4784LWO | ||
| 3 | Move soft top to repair position R2 | AR77.30-P-1030LWR | |
| 4 | Remove side airbag in the rear and place to one side with connected electric line | Model 205.4 with code 298 (Rear sidebag with belt force limiter) Model 238.4 with code 293 (Sidebags in rear) |
AR91.60-P-0694CLW |
| 5 | Remove bolt (3) on soft top operation hydraulic cylinder (2) and remove towing eye (4) | ||
| 6 | Detach hook (6) from header bow (9) | ||
| 7 | Unclip cover (7) and fold to side | ||
| 8 | Detach nuts (8) and remove cable (1) to side | ||
| 9 | Fully expose cable (1) | ||
| 10 | Remove adhesive holder (5) | ||
| 11 | Unclip all holders (arrows a) of cable (1) | Fig 1 | |
| 12 | Install in the reverse order | ||
| 13 | Set cable (1) | AR77.33-P-1051LWP |