Remove, Install Draft Stop - AR77.25-P-2000LWR

Model 205.4 

with code 288 (Draft stop for convertible) 

Model 238.4 

with code 288 (Draft stop for convertible) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Risk of injury  when performing check and repair work in area of roll bar	Keep body parts out of the area where the roll bars extend. Do not use the cover in the area of the roll bar as a storage place for objects.	AS91.00-Z-0003-01LCA
	Remove/install
1	Remove both seat side bolsters in the rear passenger compartment.		AR91.12-P-1711LWR
2	Remove trim from the roll bars.		AR68.30-P-1380LWR
3	Loosen trims (2) in the area of the draft stop (1).
4	Disconnect electrical connectors (3) and unclip plug sockets.
5	Unscrew screw/bolts (4).
6	Unclip bottom draft stop (1) and remove upward (arrows).	Installation:  Ensure that draft stop (1) is seated correctly on retaining clips (5).
7	Prepare draft stop (1) for installation.	When installing new draft stop (1). Model 238.4 with code 288 (Draft stop for convertible)	AR77.25-P-2000-01LWP
		Model 238.4 with code 288 (Draft stop for convertible) Screw, angle bracket to draft stop/crossmember	BA77.25-P-1002-03A
8	Install in the reverse order.