Remove/Install Ambiance Illumination Control Unit - AR82.20-P-0001LWM
Model 205 with code 877 (Ambient lighting)
Model 253 (except 253.992/993) with code 877 (Ambient lighting)
Model 293 with code 877 (Ambient lighting)
Shown on model 205.### 1# with transmission 725
Shown on MODEL 205.### 1#
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Commission ambient lighting control unit (N162). | When replacing the ambient lighting control unit (N162). | |
| Model 293 with code 877 (Ambient lighting) | AD00.00-P-2000-06FR | ||
| Model 205 with code 877 (Ambient lighting) | AD00.00-P-2000-04B | ||
| Model 253 (except 253.992/993) with code 877 (Ambient lighting) | |||
| 2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 3 | Remove floor covering in front passenger footwell. | Model 205 with code 877 (Ambient lighting) | AR68.20-P-2070LW |
| Model 253 (except 253.992/993) with code 877 (Ambient lighting) | |||
| Model 293 with code 877 (Ambient lighting) | AR68.80-P-0008EQ | ||
| 4 | Unscrew nuts (1) and remove footrest (2). | ||
| 5 | Unscrew nut (3) and place prefuse box in vehicle interior (F32/4) with attached electric lines to one side. | ||
| 6 | Unclip electric line (5) from holder (11). | Fig 2 | |
| 7 | Disconnect electrical connectors (6) from powertrain control unit (N127). | ||
| 8 | Disconnect electrical connector (8) from park pawl capacitor (C8). | Model 205 (except 205.012/013/047/053/147/212/213/247/253) with transmission 722 with code 877 (Ambient lighting) Model 205 (except 205.012/013/047/053/147/212/213/247/253) with transmission 725 with code 877 (Ambient lighting) Model 205 with transmission 724 with code 877 (Ambient lighting) Model 253 (except 253.992/993) with transmission 724 with code 877 (Ambient lighting) Model 253 (except 253.992/993) with transmission 725 with code 877 (Ambient lighting) |
|
| 9 | Unscrew nuts (10) and place holder (11) with control units into footwell. | ||
| 10 | Disconnect electrical connector (12) from ambient lighting control unit (N162). | ||
| 11 | Unscrew nut (13) and remove ambient lighting control unit (N162). | ||
| 12 | Install in the reverse order. |