Remove/Install Panoramic Sliding Sunroof Wind Deflector Bearing - AR77.21-P-0102MFA

Model 118, 177 

with code 413 (Automatic panoramic sliding sunroof) 

Shown on left side of vehicle 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Remove wind deflector for panoramic sliding sunroof.		AR77.21-P-0101MFA
2	Lift catch tab (1) with a suitable tool, push bearing (2) out backward in direction of arrow and remove.	Carefully release and move out bearing (2). The guides may otherwise be damaged. Ensure correct seat of bearing (2). The instructions are shown only for one side and must be carried out on both sides.
3	Install in the reverse order.