Remove/Install Wind Deflector For Panoramic Sliding Sunroof - AR77.21-P-0101MFA

Model 118, 177 

with code 413 (Panoramic sliding sunroof/glass roof) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Open panoramic sliding sunroof completely.
2	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
3	Unscrew bolts (2).
4	Unclip wind deflector (1) from guide rails.	Clipped once each on the left and right side of the vehicle.
5	Set up wind deflector (1) such that it points vertically upward.	When replacing, press the springs of the wind deflector (1) forward to position the springs in their working area. The springs and wind deflector (1) will otherwise be damaged.
6	Push the wind deflector (1) forward in front of the bearing pin (3) and remove the wind deflector (1).
7	Install in the reverse order.