Retrofit Adaptive High Beam Assist Plus - AN82.10-P-0011W
Model 172.### 1# as of 3/1/16
with code 476 (Lane keeping assist)
with code 642 (Headlamps, LED, dynamic, right-side traffic)
Model 172.### 1# as of 3/1/16
with code 513 (Speed Limit Assist)
with code 642 (Headlamps, LED, dynamic, right-side traffic)
Model 172.### 2# as of 3/1/16
with code 476 (Lane keeping assist)
with code 641 (Headlamps, LED, dynamic, left-side traffic)
Model 172.### 2# as of 3/1/16
with code 513 (Speed Limit Assist)
with code 641 (Headlamps, LED, dynamic, left-side traffic)
| Initial startup | |||
| 1 | Order retrofitting via parts ordering process, specifying vehicle identification number (FIN) | Info-Center → PIT After sales → Parts → Genuine parts → Cars |
|
| Update Vehicle Documentation (VeDoc) | |||
| 2 | Enter special equipment into the on-line vehicle data card | ||
| 3 | Attach note Adaptive High Beam Assist retrofitted as per AN82.10-P-0011W under field organization texts to design group 54 and design group 82 | ||
| 4 | Connect diagnostic system and select vehicle using FIN | ||
| AD00.00-P-2000-04A | |||
| 5 | Carry out variant coding using software calibration number (SCN) | Signal acquisition and actuation module (SAM) Multifunction camera (MFK) Instrument cluster (KI) Headlamp (SW) Chassis gateway (FWGW) |
|
| 6 | Disconnect diagnostic system | ||
| AD00.00-P-2000-04A | |||
| Check | |||
| 7 | Perform function test |
PARTS ORDERING NOTE
| Part no. | Designation | Quantity |
|---|---|---|
| KG 99 (see EPC) | Parts kit for automatic high beam control Plus software retrofit | 1 |