Remove/Install HERMES Antenna - AR82.95-P-0030W
Model 172
with code 360 (HERMES UMTS)
Model 172
with code 362 (HERMES communications module LTE)
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 2 | Remove radio display | Model 172 with code 360 (HERMES UMTS) Model 172 with code 362 (HERMES communications module LTE) Model 172.4 with code 360 (HERMES UMTS) with code 505 (Radio 20 NTG5, not navigation-enabled) Model 172.4 with code 360 (HERMES UMTS) with code 522 (Audio 20 CD including preinstallation for Garmin® MAP PILOT) Model 172.4 with code 360 (HERMES UMTS) with code 531 (COMAND® APS) Model 172.4 with code 362 (HERMES communications module LTE) with code 505 (Radio 20 NTG5, not navigation-enabled) Model 172.4 with code 362 (HERMES communications module LTE) with code 522 (Audio 20 CD including preinstallation for Garmin® MAP PILOT) Model 172.4 with code 362 (HERMES communications module LTE) with code 531 (COMAND® APS) |
AR82.60-P-7722W |
| 3 | Release and disconnect the electrical connector on the HERMES antenna (1) | ||
| 4 | Lift the retaining lugs (arrows) with a suitable tool, move the HERMES antenna (1) slightly backwards, rotate it by 90° and remove it | ||
| 5 | Install in the reverse order |