Remove/install front bumper - AR88.20-P-2000RK
MODEL 231
Shown on model 231 up to model year 2016 with code U60 Active engine hood (pedestrian protection)
Shown on model 231 up to model year 2016
Shown on model 231 up to model year 2016 with code 610 (Night View Assist)
| General information on the impact absorber | AH88.20-P-1000-01A | ||
| Remove/install | |||
| 1 | Disconnect battery ground line | Model 231 with code U60 (Active Bonnet (Pedestrian protection)) |
AR54.10-P-0003RK |
| 2 | Lift vehicle with lifting platform | AR00.60-P-1000TX | |
| 3 | Loosen front section of fender liner | AR88.10-P-1300RK | |
| 4 | Disconnect electrical connectors (3, 4, 5) | ||
| 5 | Disconnect washer fluid hose connector (13) | Model 231 with code 610 (Night view assist) |
|
| AP82.35-P-8210EW | |||
| 6 | Remove bolts (2) | ||
| 7 | Remove screw/bolts (8, 9) | ||
| 8 | Unscrew bolts on bumper (1) from fender (6) at top | Model 231 as of model year 2017 | |
| 9 | Press bumper (1) in direction of arrow and unhook from bracket (7) | ||
| 10 | Disengage catch hook (11) upward | ||
| 11 | Remove bumper with aid of helper until electrical connector (12) is accessible | Model 231 with code 610 (Night view assist) |
|
| 12 | Disconnect electrical connector (12) from infrared camera (14) | Model 231 with code 610 (Night view assist) |
|
| 13 | Pull bumper (1) out of guide (10) and remove | ||
| 14 | Check front bumper pedestrian protection sensor for any kind of damage (cracks, holes, kins, etc.) | Model 231 with code U60 (Active Bonnet (Pedestrian protection)) |
|
| Notes on pedestrian protection sensor | AH91.60-P-0001-01A | ||
| If damage is visible. ↓ Replace pedestrian protection sensor |
AR91.60-P-0950RK | ||
| 15 | Install in the reverse order | ||
| 16 | Calibrate infrared camera (14) with diagnostic tester | Model 231 with code 610 (Night view assist) | AR54.30-P-3008LF |