Remove/install Bluetooth antenna - AR82.62-P-8980RK

MODEL 231 

Fig 1: Bluetooth Antenna Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Bluetooth Antenna Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Switch off ignition and remove transmitter key (A8/1) or KEYLESS-GO start/stop button (S2/3) from electronic ignition lock control unit (N73)	KEYLESS-GO start/stop button (S2/3) only with CODE 889 (KEYLESS-GO).
2	Remove automatic air conditioning control and operating unit (N22/7)		AR83.40-P-6350RK
3	Expose antenna cable (1) and unclip Bluetooth® antenna (A2/91)	Carefully unclip Bluetooth® antenna (A2/91). Otherwise damage may occur.
4	Remove COMAND controller unit (A40/3) from the instrument panel until the electrical connectors on the back are accessible	Only perform the operation steps that are required for disconnecting the electrical connector (2).	AR82.85-P-1100RK
5	Disconnect electrical connector (2) on back of COMAND controller unit (A40/3)
6	Remove Bluetooth® antenna (A2/91) with connected antenna cable (1)
7	Push COMAND controller unit (A40/3) into instrument panel
8	Install in the reverse order