Remove/install flywheel/drive plate - AR03.30-P-8001MUB
MODEL 217 with ENGINE 279
MODEL 222 with ENGINE 277, 279
MODEL 463 with ENGINE 279
| Remove/install | |||
| 1 | Remove transmission | Model 463 with engine 279 with transmission 722.9 | AR27.10-P-0500GW |
| Model 217, 222 with engine 277, 279 with transmission 722.9 (except 722.96/97) | AR27.10-P-0500LF | ||
| 2 | Install retaining lock | AR03.30-P-5000MUB | |
| 3 | Remove screw/bolts (2) from drive plate (1) | ||
| *BA03.30-P-1002-01U | |||
| 4 | Remove washer (3) | ||
| 5 | Remove drive plate (1) | ||
| 6 | Install in the reverse order | ||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 7 | Carry out an engine test run and check engine for leaktightness | ||
| 8 | Carry out initialization | When replacing the clutch plate (1) | |
| Model 463 with engine 279 | AD00.00-P-2000-04A | ||
| Model 217 with engine 279 Model 222 with engine 277, 279 |
AD00.00-P-2000-04B |
FLYWHEEL, DRIVE PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | Engine 277 | Engine 279 | ||
|---|---|---|---|---|---|
| BA03.30-P-1002-01U | Screw/bolt, starter ring gear/drive plate to crankshaft | Stage 1 | Nm | 45 | 45 |
| Stage 2 | ∠° | 90 | 90 | ||