Remove/Install Front Panoramic Glass Roof - AR77.21-P-0500ME
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.
Model 167.1/9
With Code 413 (Automatic panoramic sliding sunroof)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove | |||
| 1 | Unclip front trims from the sliding roof panel (2) and remove. | AR77.21-P-6920ME | |
| 2 | Mark position of the screws (1, 3). | ||
| 3 | Remove screws (1, 3). | ||
| 4 | Remove sliding roof panel (2) upward and set down on a suitable base. | ||
| Install | |||
| 5 | Place sliding roof panel (2) on the marked positions and tighten screws (1) slightly by hand. | ||
| 6 | Close sliding roof panel (2) and check gap dimension from outside with a helper; if necessary, loosen screws (1) (put into tilt position again) and carry out fine adjustment while the sliding roof panel is closed (2). | AR77.21-P-6924ME | |
| 7 | Tighten screw (3). | *BA77.21-P-1002-01F | |
| 8 | Tighten screws (1). | *BA77.21-P-1002-01F | |
| 9 | Install front trims on the sliding roof panel (2). | AR77.21-P-6920ME | |
| Concluding tasks | |||
| 10 | Normalize panoramic sliding sunroof using vehicle diagnosis system and perform teach-in run for automatic reversing function. | ||
| AD00.00-P-2000-06ME |
PANORAMIC ROOF
| Number | Designation | Model 167 with code 413 (Automatic panoramic sliding sunroof) | |
|---|---|---|---|
| BA77.21-P-1002-01F | Screw, sliding roof panel to sliding roof | Nm | 6 |