Remove/Install Fuse And Relay Module In Rear - AR54.15-P-0001ME

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.

Model 167

MODIFICATION NOTES

10.09.2019

"Remove service flap and line bracket", added.

Operation steps 1.1 and 4

Courtesy of MERCEDES-BENZ USA

Shown on model 167.1

Fig 1: Fuse And Relay Module In Rear Components Location - Model 167.9

Courtesy of MERCEDES-BENZ USA

Shown on model 167.9

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1.1	Remove service flap in right load compartment trim.	Model 167.9 except code M036 (Maybach version)
1.2	Remove right load compartment cover.	Model 167.1/3 Model 167.9 with code M036 (Maybach version)
		Model 167.1	AR68.30-P-4800ME
		Model 167.3	AR68.30-P-1185MEC
		Model 167.9 with code M036 (Maybach version)	AR68.30-P-1185MEM
2	Disconnect ground line from on-board electrical system battery.		AR54.10-P-0003ME
3	Remove line brackets (3) from holder (6).	The number of line brackets (3) varies depending on the vehicle equipment.
4	Remove line bracket (7) from holder (2).	Model 167.9
5	Remove screw (1).
6	Remove bracket (6) with rear fuse and relay module (F152/2) from bracket (2).	Make sure that the bracket (6) is correctly seated in the bracket (2) (arrows).
7	Remove bolts (5).
8	Detach rear fuse and relay module (F152/2) from bracket (6).	The rear fuse and relay module (F152/2) is clipped into the corners on the holder (6).
9	Remove nut (4) of positive line from rear fuse and relay module (F152/2).	Nut, positive line to rear fuse and relay module	*BA54.15-P-1004-01L
10	Release and disconnect all electrical connectors from rear fuse and relay module (F152/2).
11	Unclip all fuse holders and place to one side.
12	Remove rear fuse and relay module (F152/2).
13	Install in the reverse order.

FUSE AND RELAY BOX

Number	Designation			Model 167
BA54.15-P-1004-01L	Nut, positive line to rear fuse and relay module	M8	Nm	16