Remove/Install Paneling On A-Pillar - AR68.30-P-4050LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205

Model 213

Model 238.4

Model 253

Model 293

MODIFICATION NOTES

28.02.2019

Special tool assembly wedge replaced by special tool long wedge.

Operation Step 3

AR68.30-P-4050-03LW

	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Completely open soft top.	Model 205.4, 238.4
2	Remove sunvisor	Model 205.4	AR68.60-P-5480NKB
		Model 238.4	AR68.60-P-5480LWO
3	Remove A-pillar trim.	Model 205.4, 238.4	AR68.30-P-4050-03LW
		Model 205.0/1/2/3, 213, 253, 293	AR68.30-P-4050-03LWA
		Long wedge	Fig 1
		Model 205 0/1/2/3 213 253 293 Clip remover	Fig 2
4	Install in the reverse order

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA