Detach/Attach A-Pillar Trim - AR68.30-P-4050-03LWA

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205.0/1/2/3, 213, 253, 293

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA

Unclip cover (2) with clip remover.
Detach edge guard (3) in area of A-pillar paneling (1).
Ensure that edge guard (3) is seated correctly.
Unclip A-pillar trim (1) using long wedge at retaining clip (4) and retaining clamp (5).
Slightly pivot A-pillar paneling (1) at top toward inside and remove toward rear out of instrument panel.
Install in the reverse order.

Courtesy of MERCEDES-BENZ USA