Remove/Install Rear Axle Electronic Level Control Unit - AR32.33-P-0022LWT
Model 213.2
except code 489 (AIRMATIC Dual Control/semi-active air suspension)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on HANDS-FREE ACCESS | Model 213.2 with code P17 (KEYLESS-GO package) except code 489 (AIRMATIC Dual Control/semi-active air suspension) | AH80.61-P-0001-01A | |
| Remove/install | |||
| 1 | Perform initial startup of rear axle electronic level control system control unit (N97) | When replacing rear axle electronic level control system control unit (N97). | |
| 2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 3 | Remove left side load compartment lining | AR68.30-P-1185LWE | |
| 4 | Unscrew nut (1) | ||
| 5 | Separate electrical connectors (2) | ||
| 6 | Remove rear axle electronic level control system control unit (N97) | ||
| 7 | Install in the reverse order |