Remove/Install Tail Lamp Unit - AR82.10-P-4731MFV

Model 118.3, 177.1/9 

Fig 1: Tail Lamp Unit Components Location - Model 118.33

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove rear-end center-section trim.		AR68.30-P-4786MFV
2	Loosen left or right trunk lining at side in trunk until the nuts (1) are accessible.	: Ensure that the edge guard is correctly seated in the working area.	AR68.30-P-4800MFV
3	Unscrew nuts (1).
4	Remove rear lamp units (E3, E4) until the electrical connector is accessible.	Do not crush or kink or subject lines to tension. This leads to line damage. : Position rear lamp units (E3, E4) carefully. Otherwise adjacent parts may be damaged.
5	Release and disconnect electrical connector of rear lamp units (E3, E4).	: Make sure that the grommet (2) is seated correctly.
6	Install in the reverse order.