Remove/Install Brake Cover Plate Of Rear Disk Brake - Ar42.10-D-0006TSR
Model 907
Shown on model 907 without code IT5 (5.0 tons)
Shown on model 907 with code IT5 (5.0 tonner)
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notes on repairs to brake system | AH42.00-P-0003-01A | ||
| Remove/install | |||
| 1 | Remove brake shoes of parking brake. | Model 907 except code B25 (Electric parking brake) except code IT5 (5.0 tonner) |
AR42.20-D-0530TS |
| Model 907 with code IT5 (5.0 tonner) except code B25 (Electric parking brake) |
AR42.20-D-0530TSB | ||
| 2 | Remove wheel hub (2). | Model 907 with code IT5 (5.0 tonner) | AR35.20-D-0310H |
| Model 907 with rear axle 741.422/453/454/455/456 with code IT5 (5.0 tonner) | AR35.20-D-0310TSR | ||
| 3 | Remove rear axle shaft. | Model 907 except code IT5 (5.0 tonner) | AR35.30-D-0620H |
| Model 907 with rear axle 741.421/423 except code IT5 (5.0 tonner) | AR35.30-D-0620TSS | ||
| 4 | Remove brake cover plate (1). Notes on threaded connections fastened using a tightening angle-based tightening process |
AH00.00-P-0020-01A | |
with code IT5 (5.0 tonner) except code B25 (Electric parking brake) Screw, brake cover plate to axle |
*BA42.20-N-1006-01TS | ||
| 5 | Install in the reverse order. |
| Number | Designation | Model 907 with code IT5 (5.0 tonner) except code B25 (Electric parking brake) | ||
|---|---|---|---|---|
| BA42.20-N-1006-01TS | Screw, brake cover plate to axle | Stage 1 | Nm | 15 |
| Stage 2 | ∠ ° | 25 | ||