Retrofit Device Installation Frame In Roof Lining At Front - An54.61-D-2003-01TS

Warning	Risk of injury  caused by slipping when clamping blade in the multicutter and by splinters when cutting out bonded windows	Wear protective gloves and safety glasses.	AS65.00-Z-0003-01A
Caution	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Notes on carrying out repair work in the vehicle interior		AH68.00-N-0001-01S

Model 907 except code FF8 (Single-size slot at front under roof liner) 

The following operation steps are shown on a vehicle without code D03 (Roof and rear-end doors, high version), without code D05 (Super high roof) and without code D06 (Super high roof painted in vehicle color). On vehicles with code D03 (Roof and rear-end doors, high version) or code D05 (Super high roof) or code D06 (Super high roof painted in vehicle color), the operation steps are performed in the same way.

Prepare roof lining (1) 

1. Cut out opening in roof lining (1).

   Cut out opening indicated by embossing on roof lining (1).

   Commercially available devices/tools 

   Oscillation saw

2. Attach frame (2) to roof lining (1).

   Make sure that the frame (2) is positioned and engaged correctly (arrows A).

   Install bracket (4) 

3. Install pull-in nuts in roof bow (3) (arrows B).

   Commercially available devices/tools 

   Blind rivet nut pliers

4. Install holder (4).

   Screw in bolts (5) to do this.

   Install device installation frame (6) 

5. Retrofit device installation frame (6).

   To do so, slide device installation frame (6) through frame (2) into holder (4).

6. Install clamps (7) as shown.