Remove/Install Extinguishing Agent Tank - AR86.10-P-0100LFS

Model 222.1 

with code Z21 (Fire extinguishing system) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Topical note	Notes on squib on extinguishing agent tank	Model 222.1 with Code Z07 (Maximum protection) with Code Z21 (Fire extinguishing system)	AH86.10-P-0001-04A
	Notes on aerosol extinguishing agent tank	Model 222.1 with Code Z07 (Maximum protection) with Code Z21 (Fire extinguishing system)	AH86.10-P-0001-02A
	Remove
1	Switch off ignition and remove transmitter key
2	Open paneling (7) on extinguishing agent tank (1)
3	Unscrew safety pin (8) from valve body (9)	To secure extinguishing agent tank (1).
4	Use safety pin (8) and screw into valve body (9)	Do not screw in side with red marking (arrow) on locking pin (8). Otherwise the extinguishing agent tank (1) is not secured. To secure extinguishing agent tank (1).
		Locking pin to extinguishing agent tank	*BA86.10-P-1008-01B
5	Remove fuse 4 from fuse box I, rear right wheel well
6	Disconnect electrical connectors from extinguishing agent tank (1)
	Notes for extinguishing agent tank pressure monitor switch		AH86.10-P-0001-03A
7	Unscrew union nut (3) and carefully remove extinguishing agent pipe (4) from connector (6) on extinguishing agent tank (1)
8	Open hose clamps (2)
9	Remove extinguishing agent tank (1)
	Install
10	Install extinguishing agent tank (1) in bracket
11	Close bolt clamps (2)
12	Carefully guide extinguishing agent tube (4) into connection piece (6) and tighten union nut (3)	Threaded connections for extinguishing agent lines	*BA86.10-P-1003-01B
13	Connect electrical connectors to extinguishing agent tank (1)
	Notes for extinguishing agent tank pressure monitor switch		AH86.10-P-0001-03A
14	Insert fuse 4 into fuse box i, right rear wheel arch
15	Unscrew safety pin (8) from valve body (9)	To release extinguishing agent tank (1).
16	Use safety pin (8) and screw into valve body (9)	Screw in side of red marking on locking pin (8). Otherwise the extinguishing agent tank (1) is not operational. To release extinguishing agent tank (1).
		Locking pin to extinguishing agent tank	*BA86.10-P-1008-01B
17	Close paneling (7) on extinguishing agent tank (1)
	Check
18	Perform self-test for fire extinguishing system		AR86.10-P-0101-01LFS

FIRE EXTINGUISHING SYSTEM

Number	Designation			MODEL 222.1/9 with CODE Z07 and CODE Z21
BA86.10-P-1003-01B	Threaded connections for extinguishing agent lines	Size 14	Nm	12
		Size 17	Nm	-
		Size 19	Nm	-

FIRE EXTINGUISHING SYSTEM

Number	Designation		MODEL 222.1/9 with CODE Z07 and CODE Z21
BA86.10-P-1008-01B	Locking pin to extinguishing agent tank	Nm	6