Remove/Install Rear Axle Pressure Reservoir - AR32.50-P-0011LF
Model 217, 222
With Code 487 (Active Body Control (ABC))
MODIFICATION NOTES
| 25.11.2014 | Nut, rear valve unit pressure reservoir to body | BA32.50-P-1011-03B |
Shown on model 222
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning from swallowing hydraulic fluid. | Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses. | AS00.00-Z-0013-01A | |
| Topical note | Notes on fitting hydraulic lines and hoses | AH32.50-P-0001-02A | |
| Notes on Active Body Control suspension | AH32.50-P-0001-01N | ||
| Remove/install | |||
| 1 | Reduce pressure in ABC system using diagnostic equipment | AR32.50-P-0001-01LF | |
| AD00.00-P-2000-04B | |||
| 2 | Unfasten cover (1) on left side | ||
| 3 | Remove left heat shield (2) | ||
| 4 | Remove bracket (3) in wheel arch | ||
| 5 | Clean the area surrounding separation point at hydraulic line (5) | ||
| 6 | Remove screw/bolt (4) and take off hydraulic line (5) | *BA32.50-P-1012-03B | |
| 7 | Seal pressure reservoir (6) and hydraulic line (5) using suitable stop plugs | Fig 1 | |
| 8 | Unscrew nuts (7) at pressure reservoir (6) | *BA32.50-P-1011-03B | |
| 9 | Fold trunk floor upwards and remove spare wheel well paneling | ||
| 10 | Remove pressure reservoir (6) | ||
| 11 | Dispose of pressure reservoir (6) properly | When replacing pressure reservoir (6) | |
| 12 | Install in the reverse order | ||
| 13 | Fill and bleed ABC system | AR32.50-P-0021SX |
ACTIVE BODY CONTROL
| Number | Designation | Model 217 | Model 222 | ||
|---|---|---|---|---|---|
| BA32.50-P-1011-03B | Nut, rear valve unit pressure reservoir to body | Stage 1 | Nm | 4 | 4 |
| Stage 2 | Nm | 8 | 8 | ||
ACTIVE BODY CONTROL
| Number | Designation | Model 217 | Model 222 | ||
|---|---|---|---|---|---|
| BA32.50-P-1012-03B | Bolt, high-pressure line to rear valve unit pressure reservoir | M8 | Nm | 20 | 20 |