Clean Fire Extinguishing System - AR86.10-P-0120LFS

Model 222.1 

with code Z21 (Fire extinguishing system) 

	Remove
1	Remove fire extinguisher agent reservoir		AR86.10-P-0100LFS
2	Connect compressed air flushing connection to extinguishing agent pipes	The compressed air flushing connection for extinguishing lines can be obtained from the fire extinguishing system manufacturer.
3	Connect compressed air hose to compressed air flushing connection
4	Remove end pieces caps of extinguishing agent lines in engine compartment
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
5	Lift vehicle on vehicle lift
6	Remove caps on spray nozzle on underfloor
	Check
7	Connect compressed air hose to workshop compressed air supply	Pressure approx. 10 bars.
	Risk of injury  to skin and eyes from particles when blowing out extinguishing agent lines	Wear protective gloves, protective clothing and safety glasses.	AS86.00-Z-0005-01B
8	Check extinguishing agent outlet holes for spray nozzles as well as for end pieces on extinguishing agent lines in engine compartment for air outlet	The fire extinguishing system should be cleaned outside or in well-ventilated rooms.
9	Disconnect compressed air hose from workshop compressed air supply
	Clean
10	Check extinguishing agent outlet holes for spray nozzles as well as for end pieces on extinguishing agent lines in engine compartment with suitable tool
11	Check air outlet on spray nozzles again
12	Replace spray nozzles on fire extinguishing system	Model 222.1 with code Z07 (B7 armoring on special protection version) with code Z21 (Fire extinguishing system) If spray nozzle is soiled extremely.
			AR86.10-P-0118LFS
	Risk of injury  to skin and eyes from particles when blowing out extinguishing agent lines	Wear protective gloves, protective clothing and safety glasses.	AS86.00-Z-0005-01B
13	Connect compressed air hose to workshop compressed air supply and again check spray nozzles and end pieces on extinguishing agent lines in engine compartment for air outlet	After cleaning or replacing. Pressure approx. 10 bars.
14	Disconnect compressed air hose from workshop compressed air supply. If necessary, repeat cleaning
15	Blow out engine fire extinguishing system temperature sensor on front engine compartment paneling and rear fire extinguishing system temperature sensor with compressed air and remove dirt	Contaminated engine fire extinguishing system temperature sensor and rear fire extinguishing system temperature sensor can influence the fire extinguishing system function.
	Install
16	Install caps on spray nozzles on underfloor	Ensure that caps are seated correctly, replace caps if necessary.
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
17	Lower vehicle
18	Remove compressed air flushing connection
19	Install extinguishing agent reservoir		AR86.10-P-0100LFS
20	Install caps on end pieces of fire extinguishing agent lines in engine compartment	Ensure that caps are seated correctly, replace caps if necessary.
	Clean
21	Blow out engine fire extinguishing system temperature sensor on suspension strut tower with compressed air and remove dirt	Contaminated engine fire extinguishing system temperature sensor can influence the function of the fire extinguishing system.