Remove/Install Window Lifter Pressure Switch - AR72.10-P-0015LF

Model 222

with code Z07 (B7 armoring on special protection version)

Courtesy of MERCEDES-BENZ USA

	Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning from swallowing hydraulic fluid.	Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses.	AS00.00-Z-0013-01A
	Remove/install
1	Remove power window from front door		AR72.10-P-1800LFS
2	Release oil pump (3) far enough to gain access to pressure switch (1)		AR72.10-P-0016LF
3	Expose electric line (2.1) of electrical wiring harness (2) and unpin from electrical connector	: Replace cable tie (4).
		Wiring harness repair kit, basic	Fig 2
		New passenger car wiring harness repair kit	Fig 1
4	Remove pressure switch (1) and take	: Replace seal of pressure switch (1). Collect escaping oil in a suitable vessel.
		Pressure switch to window lifter pressure reservoir	*BA72.10-P-1020-01Y
5	Install in the reverse order

FRONT DOOR

Number	Designation		Model 222 with code Z07 (B7 armoring on special protection version)
BA72.10-P-1020-01Y	Pressure switch to window lifter pressure reservoir	Nm	50

Fig 1: Identifying New Passenger Car Wiring Harness Repair Kit (220 589 04 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ USA