Remove/Install Rear Roller Sun Blind Motor For Panoramic Roof - AR77.21-P-0492LF
Model 222
with code 398 (Panoramic roof with MAGIC SKY CONTROL)
Model 222
with code 413 (Automatic panoramic sliding sunroof)
Fig 1: Rear Roller Sun Blind Motor For Panoramic Roof Components Location - Model 222 With Code 398, 413
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove headliner and lay down on vehicle interior | Model 222.0 with code 398 (Panoramic roof with MAGIC SKY CONTROL) Model 222.0 with code 413 (Automatic panoramic sliding sunroof) |
AR68.30-P-4300LF |
| Model 222.1 with code 398 (Panoramic roof with MAGIC SKY CONTROL) |
AR68.30-P-4300LFN | ||
| Model 222.1 with code 413 (Automatic panoramic sliding sunroof) Model 222.9 with code 398 (Panoramic roof with MAGIC SKY CONTROL) except code Z07 (Top protection) Model 222.9 with code 413 (Automatic panoramic sliding sunroof) except code Z07 (Top protection) |
|||
| 2 | Release and disconnect electrical connection (1) | ||
| 3 | Unscrew bolts (2) and remove rear panoramic sliding roof roller sun blind drive cable (M12/6) | ||
| 4 | Install in the reverse order | ||
| 5 | Close diagnostic system, normalize panoramic roof and perform teach-in run for automatic reversing function of the panoramic roof | ||
| AD00.00-P-2000-04B |