Remove/install license plate lamps - AR82.10-P-5161NKC

MODEL 117 

Shown on MODEL 117.3 

Fig 1: License Plate Lamps Remove/Install Components - Shown On Model 117.3

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove trunk lid handle strip (2)	MODEL 117.3
			AR88.50-P-5062NKC
2	Remove left license plate lamp (E19/1) or right license plate lamp (E19/2) from trunk lid (1)	Clip left license plate lamp (E19/1) or right license plate lamp (E19/2) by hand into trunk lid (1). Removal:  Apply clip remover (3) at side under left license plate lamp (E19/1) or right license plate lamp (E19/2), release catch hook (arrow A) and keep released. Then lift left license plate lamp (E19/1) or right license plate lamp (E19/2) out of trunk lid (1) at side. Repeat process on other side at catch hook (arrow B).
		Clip remover	Fig 2
3	Release and disconnect electrical plug (4)
4	Remove left license plate lamp (E19/1) and right license plate lamp (E19/2)
5	Install in the reverse order

Fig 2: Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA