Remove/Install Right Rear Seat Backrest Cover - AR91.18-P-1878LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 205.0/1 with code 287 (Through-loading feature)
MODEL 205.2
MODEL 205.3
MODEL 253, 293
Shown on Model 205.2
| Remove/install | |||
| 1 | Remove pivot bearing of right seat backrest with right rear passenger compartment seat backrest inclination switch. | AR91.29-P-1772LW | |
| 2 | Remove head restraint guides. | AR91.16-P-1775LW | |
| 3 | Unclip cover (5) and remove. | Model 205.2 Model 253, 293 |
|
| 4 | Unhook cover (1) from seat backrest frame (2) all the way around. | Press on cover (1) once again all around the outside after hooking it in completely. |
Fig 2 |
| 5 | Guide electrical wiring harness (6) through cover (1). | Model 205.2 Model 253, 293 |
|
| 6 | Remove seat backrest frame (2). | ||
| 7 | Pull cover (1) over seat backrest padding (3). | ||
| 8 | Unclip staple wires (4) from seat backrest padding (3) starting from the outside working towards the inside. | Fig 3 | |
| 9 | Remove cover (1) from seat backrest padding (3). | The cover (1) must be aligned centrally on the seat backrest padding (3). |
|
| 10 | Pull staple wires (4) out of hose straps of cover (1). | When replacing the cover (1). |
|
| 11 | Install in the reverse order |