Prepare Rear Window For Installation - AR67.20-P-5145-03LWE
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205, 213, 238, 253, 293
| Topical note | Notes on removal/installation of rear window | AH67.20-P-2000-02A | |
| Topical note | Notes on removal/installation of windows | AH67.10-P-1000-02RT |
The bonding area must be free of dust and grease. Otherwise the adhesive force of the adhesive material starts to decrease.
Use only repair kit specified in EPC.
- Check rear window for scratches and damage.
When reusing rear window.
If there is a problem,
↓
Replace rear window.
- Fasten electrical lines on inside of rear window with adhesive tape.
The number of electrical lines varies depending on the vehicle equipment.
- Level remaining adhesive on rear window with suitable scraper down to a height of approx. 2 mm and remove loose remaining adhesive.
When reusing rear window.
- Repair damaged primer layer on rear window with primer.
When reusing rear window.
The primer must flash off for at least 10 min.
Otherwise the adhesive effect of the adhesive material will be impaired.
- Apply cleaner (activator) in bonding area on rear window and rub dry with dry cloth.
When replacing rear window.
- Coat bonding area on rear window using primer.
When replacing rear window.