Remove/Install The Liftgate Wiper Motor - AR82.30-P-6550LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205.2
Model 213.2
Model 253.1/9
Model 293
Shown on MODEL 205.2
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | AS82.30-Z-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove wiper arm (1). | AR82.30-P-6911LW | |
| 2 | Remove center liftgate trim (2). | AR72.20-P-6618LWS | |
| 3 | Disconnect electrical connector (3). | ||
| 4 | Remove screws (4) and remove liftgate wiper motor (M6/4). | ||
| 5 | Install in the reverse order. |