LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2019 >> C300 4Matic, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 341 (Electrical System - Body - 253 Chassis 4 Of 8) >> Testing & Repair >> Remove/Install Global Positioning System (GPS) Antenna - AR82.85-P-0002LW

Remove/Install Global Positioning System (GPS) Antenna - AR82.85-P-0002LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205, 213, 238, 253, 293 

with code 270 (Antenna for GPS) 

G14188069Courtesy of MERCEDES-BENZ USA

Shown on model 205.0 

G14188070Courtesy of MERCEDES-BENZ USA

Shown on model 205.0 

Fig 1: Global Positioning System (GPS) Antenna Components Location - Model 253 With Code 270 (Shown On Model 205.0)
G14188071Courtesy of MERCEDES-BENZ USA

Shown on model 205.0 

G14188072Courtesy of MERCEDES-BENZ USA
Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Remove outside mirror (9) from driver door Model 238 with code 270 (Antenna for GPS) AR88.70-P-9000LWO
    Model 205.0/1/2, 213, 253, 293 with code 270 (Antenna for GPS) AR88.70-P-9000LW
    Model 205.3/4 with code 270 (Antenna for GPS) AR88.70-P-9000CLW
2 Remove trim at outside mirror (9)   AR88.70-P-9040LF
3 Remove lock washer (5) and cover (7) Model 205.0/1/2, 213, 253, 293 with code 270 (Antenna for GPS)  
4 Pull seal (6) approx. 15 cm over the electrical lines Model 205.0/1/2, 213, 253, 293 with code 270 (Antenna for GPS)  
5 Pull electrical lines approx. 15 cm out of outside mirror (9) (arrow D) Model 205.0/1/2, 213, 253, 293 with code 270 (Antenna for GPS)  
6 Remove fuse (2) at connector housing (1) of electrical line for GPS antenna (A2/23) using a suitable screwdriver (3) (arrow A)    
7 Release connector housing (1) (arrow B) and remove (arrow C)    
8 Loosen telephone antenna (10) and place to one side with line connected Model 205, 213, 238, 253, 293 with code 270 (Antenna for GPS)
with code 274 (Telephone antenna)
AR82.62-P-0011LW 
9 Unscrew bolt (8)    
10 Pull electrical line for GPS antenna (A2/23) completely out of seal (6) and outside mirror (9)    
11 Turn GPS antenna (A2/23) (arrow E) and remove (arrow F)    
12 Install in the reverse order