Adjust Rear-Axle Toe - AR40.20-P-0261LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205

Model 213

Model 253

Model 293

Shown on right side of vehicle on model 205

Courtesy of MERCEDES-BENZ USA

Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Measure
1	Carry out input measurement.		AR40.20-P-0200LW
	Adjust
2	Loosen nut (3).
3	Adjust toe using cam bolt (2).	Assign suspension data Model 293	AR40.20-P-0203EQC
		Assign suspension data Model 213	AR40.20-P-0203LWA
		Assign suspension data Model 253	AR40.20-P-0203LWB
		Assign suspension data Model 205	AR40.20-P-0203LWC
4	Tighten nut (3).
Notice	Notes on threaded connections fastened using a tightening angle-based tightening process		AH00.00-P-0020-01A
		Self-locking nut, tie rod to rear axle carrier	*BA35.20-P-1002-04M
	Measure
5	Carry out output measurement.		AR40.20-P-0200LW

TIE ROD

Number	Designation				Model 205	Model 213
BA35.20-P-1002-04M	Self-locking nut, tie rod to rear axle carrier	When removing the tie rod	Stage 1	Nm	50	50
		When removing the tie rod	Stage 2	∠°	90	90
		When adjusting the toe		Nm	110	110

TIE ROD

Number	Designation				Model 253	Model 293
BA35.20-P-1002-04M	Self-locking nut, tie rod to rear axle carrier	When removing the tie rod	Stage 1	Nm	50	50
		When removing the tie rod	Stage 2	∠°	90	90
		When adjusting the toe		Nm	110	110