Remove/Install Rear Engine Cover - AR01.10-P-2408MRI

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Engine 264 in model 205, 253

MODIFICATION NOTES

05.02.2019

Method description revised in entire document.

Operation steps 1 to 6.

Fig 1: Rear Engine Cover Components Location - Engine 264 In Model 253

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove engine cover.		AR01.10-P-2405MRI
2	Remove elastomer bearings (1) from ball heads.	Wet elastomer bearings (1) with lubricant. Lubricant, rubber assembly 1 L	*BR00.45-Z-1010-06A
3	Tilt rear engine cover (2) toward rear and remove from threaded pin (3).
4	Guide rear engine cover (2) out of clip (4) and remove.	Ensure correct seating.
	Check
5	Check elastomer bearings (1) for damage and wear.	If there are problems, ↓ replace corresponding elastomer bearing (1).
6	Install in the reverse order.

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1010-06A	Lubricant, rubber assembly 1 L	A 000 989 03 67