Remove/Install Engine Cover - AR01.10-P-2405MRI

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Engine 264 in model 205, 253

Fig 1: Engine Cover Components Location - Engine 264 In Model 253

Courtesy of MERCEDES-BENZ USA

	Risk of injury caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Remove/install
1	Release engine cover (1) and remove.	Release elastomer bearings in the specified sequence (2, 3, 4, 5). Otherwise, the engine cover (1) will be damaged. Wet the elastomer bearings (2, 3, 4, 5) with lubricant. Lubricant, rubber assembly 1 L	*BR00.45-Z-1010-06A
2	Check elastomer bearings (2, 3, 4, 5) for damage.	If damage is present, ↓ replace corresponding elastomer bearing (2, 3, 4, 5).
3	Install in the reverse order

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1010-06A	Lubricant, rubber assembly 1 L	A 000 989 03 67