Attach/Detach Engine Hoist - AR01.10-P-2400-17MRI

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Engine 264 in model 205, 253

		Remove/install engine cover	AR01.10-P-2405MRI
		Remove/install expansion reservoir	AR20.30-P-4950LW
		Remove/install low-temperature circuit expansion reservoir	AR09.41-P-0001MRI

ENGINE RADIATOR, COOLANT HOSES AND LINES

Number	Designation		Engine 264
BA20.20-P-1002-02B	Screw, low-temperature circuit expansion reservoir to crossmember	Nm	8

Fig 1: Identifying Adaptation Plates (240 589 00 32 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Adapter Kit (240 589 01 31 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Engine Lifting Device (240 589 00 61 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Engine Hoist (205 589 00 61 00)

Courtesy of MERCEDES-BENZ USA

Remove upper engine cover (9).
Remove right engine compartment cover (7).
Remove left engine compartment cover (8).
Remove seals (10).

Courtesy of MERCEDES-BENZ USA
Remove expansion reservoir of the coolant and place to one side with connected lines.
Engine 264 in model 205
with code B01 (48V technology)

Remove expansion reservoir of the low-temperature circuit and place to one side with connected lines .

Courtesy of MERCEDES-BENZ USA
Attach adapter plates (6) to engine support fixture (1) .
Attach adapter (5) to adaptation plates (6).
Attach engine support fixtures (3) to engine support fixture (1).
Preset engine support fixture (1).
Place engine support fixture (1) on suspension strut towers and longitudinal members.
Helper required.
Adjust engine support fixture (1), align it horizontally and tighten threaded connections.
Attach shackle between support (4) and the engine suspension lug.
Tighten turnbuckle of lifting device (2).
When lifting the engine, to not subject engine mounts to tension.

The engine mount can get damaged otherwise.
Remove in the reverse order.