Detach/Attach Front Cap With Radial Shaft Sealing Ring - AR01.40-P-8922-03MFG
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Engine 139 in model 118, 177, 247
CRANKCASE, TIMING CASE COVER, END COVER
| Number | Designation | Engine 139 | |
|---|---|---|---|
| BA01.40-P-1002-01K | Screw, rear end cover to crankcase/oil pan (belt side) | Nm | 9 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1002-06A | Antifriction paste, rubber parts 2.5 kg, DBL 6867.00 | A 000 989 01 60 |
| BR00.45-Z-1028-04A | Assembly cleaner | A 000 986 56 01 |
Remove
- Remove screws (1 to 13).
- Remove front cover with radial shaft sealing ring.
- Clean sealing surface on the crankcase with assembly cleaner and a lint-free rag.
Installing
Attach insertion device on crankshaft.
- Wet the radial shaft sealing ring in the front cover with Wet with lubrication paste.
Replace front cover with radial shaft sealing ring.
- Attach front cap with radial shaft sealing ring.
- Slightly tighten screws (1 to 13) by hand.
- Tighten screws (1 to 13) in numerical sequence
.