Remove/Install Rear Door Lock - AR72.12-P-2510LFS

Model 222 

with code Z07 (B7 armoring on special protection version) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove left or right rear door module		AR72.12-P-0103LFS
2	Remove paneling (2) on inner rear door in area of left and right door lock	Mounting wedge	Fig 1
3	Connect CAN box (as control unit replacement) or control unit with power window operating unit to power window
4	Completely close side window on left or right rear door and secure with clamping pliers so it cannot drop down	Clamping pliers	Fig 2
5	Detach side window from power window and completely lower power window	Model 222 with code Z07 (B7 armoring on special protection version) with code Z13 (Left rear power window with special protection) with code Z14 (Right rear power window with special protection)
			AR72.12-P-1810LFS
6	Disconnect CAN box (as control unit replacement) or control unit with power window operating unit from power window
7	Unscrew door lock armor plate, cut butyl cord at rear of door lock armor plate with suitable cutting blade, and remove door lock armor plate	Bolt, armor plate to rear door	*BA72.12-P-1009-01S
8	Unhook operating cable (3) from door lock
9	Unscrew bolts (9) from bearing bracket (7)
10	Remove bolts (4)	Bolt, door lock to rear door	*BA72.12-P-1005-01S
11	Remove door lock (1) with operating cable (5), closing assist (6), bearing bracket (7) and electric wiring harness (8)
12	Remove operating cable (5) from door lock	When replacing door lock (1).
13	Install in reverse order

Fig 1: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Clamping Pliers (220 589 04 31 00)

Courtesy of MERCEDES-BENZ USA