Remove/Install Low-Temperature Circuit Coolant Expansion Reservoir Holder - AR09.41-P-0017XGC

Engine 177 in model 463 

as of model year 2019 

Shown on engine 177 with code KA3 (gasoline particulate filter with sensor system) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  . Skin or eye injuries may result when handling hot or glowing objects.	Wear protective gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Remove/install
1	Remove low-temperature circuit expansion reservoir upwards out of the elastomer bearings and place with attached lines to one side.		AR09.41-P-0001XGC
2	Unscrew the screws (5) on the brackets of the purge lines.	M6x1	*BA00.10-P-1002-04A
3	Unscrew the screw (3) on the non-return valve.	M6x1	*BA00.10-P-1002-04A
4	Remove screws (4) from bracket (1).	M6x1	*BA00.10-P-1002-04A
5	Remove screws (2) from bracket (1).	M6x1	*BA00.10-P-1002-04A
6	Unscrew screw (6) from bracket (1).	Engine 177 in model 463 as of model year 2019 with code KA3 (Gasoline particulate filter (OPF) with sensor system) M6x1	*BA00.10-P-1002-04A
7	Pull the bracket (1) out upwards.
8	Install in the reverse order.