Remove/Install Side Wall Lining - AR68.30-P-1450GW

Model 463 (except 463.202) 

as of model year 2013 up to model year 2019 

Fig 1: Side Wall Lining Components Location - Model 463 (Except 463.202) As Of Model Year 2013 Up To Model Year 2019

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove the trim (2) on the D-pillar.		AR68.30-P-4505GW
2	Detach sealing frame of the rear door in the area of the side wall trim (4).
3	Remove seat belt in the rear passenger compartment.	Model 463 (except 463.202/242) as of model year 2013 up to model year 2019 Remove only seat belt end fitting and seat belt guide bracket.	AR91.40-P-0681GW
4	Pry off the mounting clamps (6) of the side wall trim (4) from the door fold.	Remove mounting clamps (6) from the side wall trim (4) and attach to the door fold.
5	Remove the side wall trim (4) from the side wall at the bottom and rear (arrows).	The side wall trim (4) is fastened with expansion rivets (7). Through careful removal, damage is prevented. Install new expansion rivets (7).
6	Pull the side wall trim (4) out of the window seal (5) starting at the bottom.	Carefully pull out the side wall trim (4). Do not damage connections in window antennas Danger of breakage.
7	Remove the side wall trim (4).	The side wall paneling (4) is fastened above with the window with a Velcro strip (8) and inserted below the roof paneling in the front area.
8	Pull the seat belt strap out of the side wall trim (4).
9	Install in reverse order.