Remove/Install HERMES Antenna - AR82.95-P-0030GW

Model 463 

up to model year 2019 

with code EK1 (HERMES communications module LTE) 

Model 463 

up to model year 2019 

with code EM2 (Communications module (UMTS) for the use of Merced) 

Fig 1: HERMES Antenna Components Location - Model 463 Up To Model Year 2019 With Codes EK1, EM2

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmitter range (at least 2 m).
2	Remove right sidewall trim.	Model 463 (except 463.202) as of model year 2013 up to model year 2019 with code EK1 (HERMES communications module LTE) Model 463 (except 463.202) as of model year 2013 up to model year 2019 with code EM2 (Communications module (UMTS) for the use of Merced)	AR68.30-P-1450GW
3	Unscrew bolt (1).
4	Release HERMES antenna (2) far enough until the electrical connector on the electrical connection (3) is accessible.
5	Release and disconnect electrical connector from electrical connection (3).
6	Remove HERMES antenna (2).
7	Install in reverse order.